沉积物中壬基苯酚类雌性激素化合物的加速溶剂提取方法研究

为了同时提取和检测沉积物中的雌性激素化合物对壬基苯酚(NP)、对壬基苯酚一乙氧醚(NP1EO)和对壬基苯酚二乙氧醚(NP2EO),对加速溶剂提取体系的各种条件和对壬基苯酚类化合物的硅烷基化反应条件等进行了优化。在丙酮和丙酮-二氯甲烷混合液(丙酮含量≥60%)介质中,这些化合物的硅烷基化反应很快达到反应终点。加速溶剂提取体系的最佳提取条件是120℃、8.4MPa、两次循环提取;最佳提取溶剂是二氯甲烷。与索氏提取和酸化悬浮液液提取比较,明显提高了提取率、重现性和准确性。平均添标回收率在89.3%~95.7%之间,相对标准偏差为2.3%~13.4%。本方法对壬基苯酚、对壬基苯酚一乙氧醚和对壬基苯酚二乙氧醚化合物的检出限分别为10、30、35ng/gdw(干重)。     

Radio-Frequency Hexamethyldisiloxane Plasma Deposition: A Comparison of Plasma- and Deposit-Chemistry

This study reports on the effect of input power to hexamethyldisiloxane (HMDSO) plasmas. The power dependence of the plasma-phase species and of the surface chemistry (of the deposits) has been investigated. Neutral and positive molecular species were detected within the plasma using mass spectrometry (MS). Secondary ion mass spectrometry (SIMS) was used to probe the molecular structure of the deposits. The elemental composition of the surface was determined by XPS and the deposition rate was monitored using a vibrating quartz crystal microbalance. Neutral and cationic molecules of mass greater than HMDSO were detected in the plasma. Their formation through ion-molecule reactions is proposed. Changes in the relative concentration of plasma-phase species follow those seen in molecular species detected at the deposit surface. Thus, we believe that the molecular structure of the deposits can be related to the species present in the plasma. While traditionally the dominant mechanism in deposit formation is assumed to be free radical combinations, we propose other possibilities involving cations with the aim of putting forward a new perspective on plasma polymerization mechanisms and thereby stimulating discussion.     

Pulsed gas lenses

The concept of a pulsed gas lens is proposed. Potential applications are envisaged and preliminary experiments with pulsed ray refraction are reported.     

Isomer effects on transport properties of polyesters based on bisphenol-A

Pure gas sorption and transport properties of polyesters based on bisphenol-A and both pure isophthalic and pure terephthalic acid chloride were obtained for He, N₂, O₂, CH₄, and CO₂ at 35°C. The polymers were synthesized in our laboratory and amorphous films were prepared with a specialized solvent casting procedure. The polymer containing m-phenylene groups shows higher permselectivity for most of the gas pairs. The ideal selectivity of O₂/N₂ was increased by 33% when p-phenylene units were replaced by m-phenylene ones. On the other hand, the polyester containing only p-phenylene groups, shows higher permeability to all the gases studied. The polymer based on pure terephthalic acid chloride has a 75% higher oxygen permeability and a 1.1-fold higher carbon dioxide permeability than the isophthalic acid derivative. The polyester containing meta-phenylene units has lower T_g, higher permselectivity, lower permeability, lower fractional free volume (FFV), and lower d-spacing. The values of FFV, and lower d-spacing. The values of FFV and d-spacing were only slightly different between the two isomers. Moreover, for the sub-T_gγ transition the maximum in tan δ occured at essentially the same temperature (?55°C). The polymer with a higher concentration of p-phenylene units shows somewhat larger area under the γ-peak, indicating slightly more sub-T_g motion. The Distribution of FFV is considered to be the determining factor for the differences in transport properties observed. © 1993 John Wiley & Sons, Inc.     

高密度氩气的原子间相互作用与状态方程

本文从高密度气体的原子间相互作用出发进行思考,在修改范德瓦耳方程的基础上,提出了一种新的适用于高密度气体的状态方程,并用以对氩气临界区的等温压缩线进行计算,结果与实验值很符合.     

The variation of carrier gas viscosities with temperature

After describing simplified equations exspressing the temparature dependency of the viscosity of carrier gases (helium, nitrogen and hydrogen ) relative to a base value, absolute relationships based on the kinetic theory of gases are discussed. Comparative data obtained using various calculation methods are given and are compared to measured values. Based on the kinetic relationshipsm, of viscosity. Finally, the influence of pressure on the viscosity is also briefly discussed. As a supplement, Viscosity data are tabulated for the three gases in the range of 0°C to 400°C in increments of 2 K, calculated using the kinetic relationships.     

Size dependence of self-diffusion in the hard-square lattice gas

A striking size dependence of the mean-square displacement of diffusing particles in the two-dimensional lattice gas of hard squares has been observed by Monte Carlo simulation. It is shown that the size effect is due to the formation of a stable cage structure in small lattices when the particle concentration is high. The formation of cages is governed by a new type of percolation problem related to bootstrap percolation.     

颗粒速度在颗粒流稀疏流-密集流转变中的作用

用实验和计算模拟的方法研究了颗粒流中的颗粒速度与颗粒流特性的关系.实验研究发现当入口流量固定时，在出口上方高速运动的颗粒会使颗粒流由稀疏流向密集流转变的临界出口尺寸变小.当颗粒流转变为密集流后，颗粒速度的作用被出口上方的颗粒堆积区所消耗，最终变得与颗粒速度无关.二维分子动力学模拟计算得到了与实验相同的结论.通过二维分子动力学模拟计算，还给出了不同颗粒速度下体系的密度和速率在空间的分布图.这些分布图显示随着颗粒到达出口上方的瞬间速度的不同，颗粒堆积区的密度和高度均会改变，并最终导致颗粒流流动状态的改变. 关键词： 颗粒流 颗粒气体 分子动力学模拟     

Synthesis and properties of poly(phenylacetylenes) having two polar groups or one cyclic polar group on the phenyl ring

Phenylacetylene (PA) derivatives having two polar groups (ester, 2a – d ; amide, 4) or one cyclic polar group (imide, 5a – c ) were polymerized using (nbd)Rh⁺[(η⁶‐C₆H₅)B^?(C₆H₅)₃] catalyst to afford high molecular weight polymers (～1 × 10⁶ – 4 × 10⁶). The hydrolysis of ester‐containing poly(PA), poly( 2a) , provided poly(3,4‐dicarboxyPA) [poly ( 3 )], which could not be obtained directly by the polymerization of the corresponding monomer. The solubility properties of the present polymers were different from those of poly(PA) having no polar group; that is, poly( 2a )–poly( 2d ) dissolved in ethyl acetate and poly( 4 ) dissolved in N,N‐dimethylformamide, while poly(PA) was insoluble in such solvents. Ester‐group‐containing polymers [poly( 2a )–poly( 2d )] afforded free‐standing membranes by casting from THF solutions. The membrane of poly( 2a ) showed high carbon dioxide permselectivity against nitrogen (PCO₂/PN₂ = 62). © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5943–5953, 2006     

Preparation and properties of isobutylene–isoprene rubber–clay nanocomposites

Isobutylene isoprene rubber (IIR)‐clay nanocomposites have been prepared successfully by melt intercalation with maleic anhydride‐grafted IIR (Ma‐g‐IIR) and organophilic clay. In IIR‐clay nanocomposites, the silicate layers of the clay were exfoliated and dispersed into the monolayer. The nanocomposites exhibited greater gas barrier properties compared with those of Ma‐g‐IIR. When 15 phr clay was added, gas barrier properties were 2.5 times greater than those of Ma‐g‐IIR. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 1182–1188, 2006